1-7
Chassis Options and Accessories
:
Auxiliary Winch:
Optional planetary gear winch, mounted under the chassis. With electronic push button
controls located in the operator compartment. Hydraulic powered to provide bare drum line
pull of 15,000 lbs (6800 kg) and 40-ft/min (12 m/min) line speed on the 4th layer. Includes
125 feet (38.1 m) of 9/16-inch (14 mm) diameter 6x36 EIP-RRL-IWRC wire rope, minimum
breaking force of 33,600 pounds (150 kN). A pintle hook is recommended for 2-parting the
line with a sheave block (pintle hook and sheave block not included). Net weight: 580
pounds (265 kg)
Pintle Hook - Rear:
T-60-AOL Holland pintle hook mounted on rear frame member, provides capacity for 6,000-
pound (2700kg) tongue weight and 30,000-pound (13600kg) trailer weight. Net Weight: 15
pounds (7kg)
Pintle Hook - Front:
T-60-AOL Holland pintle hook mounted on front frame member, provides same capacity as
rear pintle hook. Net Weight: 15 pounds (7kg)
Rearview Mirrors:
One right-hand and one left-hand mirror, 6" (15 cm) wide x 16" (41 cm) high, mounted to the
cab, provide visibility to the rear and sides of the machine. Net Weight: 12 pounds (5kg)
Operator Compartment:
Standard:
Operator control station provides one-position access to all chassis and crane functions.
Includes adjustable operator's seat & seat belt, and tilting & telescopic steering column.
Also includes access point to J1939 CAN Bus System.
Operator compartment is equipped with safety glass and sliding door for entry and egress.
Door is equipped with a keyed lock to protect the operator’s station. Includes dome light,
heater/AC with 2-speed fan, 12V-electric windshield wiper on front and top glass, and
sliding sun shade for top glass. There is a sliding window in the right side of the operator
compartment. This may be removed as an emergency exit.
Drum Rotation Indicator:
Provides tactile feedback to operator when hoist drum is rotating. Feedback device attached
to hoist control handle. Feedback is proportional to hoist speed.
Air Conditioning:
Provided factory AC system using R134a refrigerant. Compact AC unit mounted in operator
area, fan-cooled condenser integral to the machine radiator tower, and belt-driven
compressor with magnetic clutch, driven by engine.
Pilot- hydraulic Controls:
Dual single-axis joysticks, at each of the operator’s hands, provide control of boom motions
and hoist. Arming command push button on the control panel enables, or disables the
function of the pilot joysticks, in conjunction with the seat switch. Key pad on dash controls
outrigger functions.
Electrical System
:
Standard 12-Volt DC:
Battery:
Dual batteries: Group 49 with 950 CCA rating.
Lighting Group:
Consists of two, 12V LED headlamps; LED tail, brake & turn signal lights, and backup
lights in rear; LED front turn signals and emergency flasher buttons at operator's station.
Emergency flashers are operated by pushing the left and right turn signal buttons
simultaneously. 12V-horn actuated by button located on hoist control joystick.
To Next Page
Loading...
