3-30
CONTROL SYSTEM AND ENGINE FAULTS
The control system of the RT-400 routinely checks itself and the rest of the system for potential
problems at start-up and during operation. When a fault is detected within the control system or
within the engine operation, an error code message will be displayed on the main display as
well as the RCL display in the operator compartment. These faults are often a connection is-
sue, calibration issue, or fault-related to the engine operation.
Prior to attempting to trace or troubleshoot the system/machine should be shut off and re-
started several times as the faults may clear themselves if they are related to a start-up issue. If
the fault persists, troubleshooting steps should be taken based off of the direction provided by
the fault(s) that are being displayed.
The level sensor is calibrated at the factory and should not need recalibration in the field. If the
level sensor is replaced in the field, then a recalibration will need to take place. See the instruc-
tions that come with the sensor.
To Next Page
Loading...
