REMOVAL OF PACKING MATERIALS
Remove all the accessories from the display package carefully. Verify that
you have all the necessary accessories before you dispose of the package.
Remove all the packing materials from the individual components. Do not
remove any labels or stickers on the back panels of the main unit.
REMOTE CONTROL BATTERY INSTALLATION
The remote control battery is already installed at the factory. To extend the life of the
original battery we have inserted a small clear plastic spacer tab between the lithium
battery and the battery terminal. You must pull this battery spacer tab out before you
use the remote control. If the remote control stops operating, replace the battery with
a new CR2025 3V lithium battery. To use the remote control, point it at the remote
sensor within a 16-foot range and at an angle of 60 degrees.
To access the battery compartment on the remote control:
Squeeze the notched tab while pulling the battery holder out.
Insert a CR2025 3V lithium battery. Make sure the battery is installed
according to the polarity indicators inside the compartment.
Slide the battery holder back into place.
CONNECTING
This system was designed to operate with AC 120V~60Hz power supply.
Connecting the unit to a power supply with different voltages could damage
the unit and also void your warranty.
1.
2.
3.
13
To Next Page
Loading...
