Brookstone IDESIGN - Radio Tuner Operation; Manual and Automatic Tuning; Preset Station Memory

21
TUNER OPERATION
Manual Operation
Press the STANDBY button on the unit or on the remote control to turn
on the unit.
Press the FUNC button to select Tuner mode. “TUNER” will show on
the display.
Press the button on the unit or on the remote control to select AM or FM.
Press the
/TUNING — or /TUNING + buttons on the unit or remote
control repeatedly to select the desired station.
Automatic Search Operation
Press and hold /TUNING — or /TUNING + buttons for
approximately 2 seconds to automatically search for the previous or next radio
station with a strong signal. Stations with a weak signal can be tuned manually.
Press and hold
/TUNING — or /TUNING + buttons for
approximately 2 seconds to start the station search again.
NOTE: During the search operation, the sound level will be muted automatically.
Preset Memory
This unit has a memory and is able to store 20 FM and 10 AM radio stations in the
preset memory.
In Tuner mode, press the button to select FM or AM.
Tune to a radio station either manually or by automatic search.
Press the PROG button on the unit or on the remote control. Then press
the FOLDER UP/M-UP button repeatedly until the desired memory position
number appears on the display.
1.
2.
3.
4.
1.
2.
1.
2.
3.