Press the PROG button again to save the programmed station.
To store the remaining stations, repeat steps 2–4.
Note: If you wish to save a new station over a current one, follow the steps
above. Any stations that have been stored in the memory will be overwritten
by the new station.
CD PLAY/STEREO and PLAY MODE buttons
Press PLAY MODE or CD PLAY/STEREO buttons repeatedly to switch
between stereo and mono reception.
When the unit is tuned into a stereo broadcast with a good signal, “STEREO”
will appear on the display.
If a stereo broadcast is received, but with interference, switch to mono mode.
Using the Preset Station Memory
Press the FOL.UP/M-UP or PRESET/FOLDER buttons on the remote or the unit
repeatedly to select preset stations that are stored in the memory.
RECEPTION TIPS
FM: Extend FM Wire Antenna completely for best reception. If a stereo broadcast
is received, “STEREO” will appear on the display.
AM: Connect the AM Loop Antenna to AM Antenna Socket. Move it 12 inches away
from the main unit, and then rotate the AM Loop Antenna for best reception.
Note: The unit will not charge the iPod in Radio mode.
4.
5.
1.
2.
3.
22
To Next Page
Loading...
