Brother CS-8072 - Stitch Width and Length Control; Adjusting Stitch Width; Adjusting Stitch Length

30
STITCH WIDTH AND LENGTH
Adjusting the stitch width
Press the stitch width manual change key. The LED lamp will light
up. Move the stitch width adjustment lever up or down. Moving the
lever up increases the stitch width, and moving the lever down
decreases the stitch width.
1 Up: Wider
2 Down: Narrower
Adjusting the stitch length
Press the stitch length manual change key. The LED lamp will
light up. Move the stitch length adjustment lever up or down. Mov-
ing the lever up increases the stitch length, and moving the lever
down decreases the stitch length.
1 Up: Longer
2 Down: Shorter
To return to the default settings (or to cancel the manual adjust-
ments), press the stitch length manual change key to turn off the
LED lamp.
To return to the default settings (or to cancel the manual adjust-
ments), press the stitch width manual change key to turn off the
LED lamp.
1
2
1
2
1
2
1
2
Generally suitable stitch width and length values are set automatically when a stitch is selected. If you prefer
to use other values, follow the instructions below to change the values.
In the following cases, the stitch width manual change key and the stitch length manual change key’s LED
lamps will be off, and the stitch width and length will return to the default values
* When the main power switch is turned to ON.
* When a different pattern is selected after the manual settings have been made.
CAUTION
If the stitches get bunched together, lengthen the stitch length and continue sewing. Do not
continue sewing without lengthening the stitch length, otherwise the needle may break and
cause injury.
CONTENTS BEFORE USE
SEWING
UTILITY STITCHES MAINTENANCE
SEWING CHART
PATTERNS
(PROGRAMMED IN
MACHINE)