Brother CS-8072 - Straight Stitch Variations; Sewing Stretch Fabrics; Adjusting Stitch Length and Needle Position

35
CONTENTS
BEFORE USE
SEWING
UTILITY STITCHES MAINTENANCE
SEWING CHART
PATTERNS
(PROGRAMMED IN
MACHINE)
6
1
5
Sewing stretch fabrics
Press the stitch width manual change key to light up the LED
lamp. Move the stitch width adjustment lever up or down to adjust
the needle position.
1 Up: 7.0 mm (1/4") [right needle position]
2 Down: 0 mm (0") [left needle position]
* The needle position cannot be changed in the straight stitch
(middle) setting.
2
1
1
2
1
2
2
1
Baste the fabric pieces together, then sew along the basting with-
out pulling the fabric.
* Do not pull the fabric while sewing.
1 Basting
Changing the stitch length
Press the stitch length manual change key to light up the LED
lamp. Move the stitch length adjustment lever up or down to ad-
just the stitch length.
1 Up: Longer
2 Down: Shorter
* For thin material which is less than 1.0 mm (1/16") thick, the
maximum stitch length will automatically be set to 4.0 mm (3/
16") while sewing, even if the length setting is longer than
4.0 mm (3/16").
Changing the needle position (only “
1
” straight stitch (left) and “
5
” triple stretch stitch)