Brother CS-8072 - Dart Seam

51
DART SEAM
1. Attach presser foot “J”, then sew a reverse stitch at the begin-
ning of the dart and sew from the wide end to the narrow end
without stretching the fabric.
1 Basting
2. Do not sew a reinforcement stitch at the end. Cut the thread at
the end leaving an excess 50 mm(2"), and then tie both ends
together.
3. Insert the ends of the thread into the dart using a needle.
4. Iron the dart to one side so that it is flat.
1
1
J
CONTENTS BEFORE USE
SEWING
UTILITY STITCHES MAINTENANCE
SEWING CHART
PATTERNS
(PROGRAMMED IN
MACHINE)