Network Scanning (For models with built-in network)
98
4
Configuring the Scan to Network Default Settings 4
a Enter the name that you want to use for the Scan to Network profile. This name will be displayed on the
LCD of the machine and can be up to 15 characters.
b The Host Address is the domain name of the CIFS server. Enter the Host Address (for example
ftp.example.com) (up to 60 characters) or the IP address (for example 192.23.56.189).
c Enter the destination folder where your document will be stored on the CIFS server (for example
/brother/abc/) (up to 60 characters).
d Choose the file name you want to use for the scanned document. You can choose from seven preset
and two user defined File Names. The file name that will be used for your document will be the file name
you selected plus the last 6 digits of the flatbed/ADF scanner counter plus the file extension (For
example, Estimate098765.pdf). You can also manually enter a File Name up to 15 characters.
e Choose the scan quality from the drop-down list. You can choose Color 100, Color 200, Color 300,
Color 600, Gray 100, Gray 200, Gray 300, B&W 200 or B&W 200x100.
f Choose the file type for the document from the drop-down list. You can choose PDF, Secure PDF, XPS
or JPEG for color or gray scale documents and PDF, Secure PDF or TIFF for B/W document.
Note
If you chose Secure PDF, the machine will ask you to enter the password before it starts scanning.
g If you want to protect the profile, check Use PIN for authentication and enter a 4-digit PIN number in
PIN Code.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
