Brother DCP-J100

64
Menu (continued) (DCP-J100 and DCP-J105) C
3.Network
(Continued)
4.WPS/AOSS — — You can easily configure
your wireless network
settings using the one-
button push method.
See .
5.WPS w/PIN Code — — You can easily configure
your wireless network
settings using WPS with
a PIN code.
6.WLAN Status 1.Status — You can see the current
wireless network status.
2.Signal — You can see the current
wireless network signal
strength.
3.SSID — You can see the current
SSID.
4.Comm. Mode — You can see the current
Communication Mode.
7.MAC Address — — You can see your
machine’s MAC address
from the control panel.
8.WLAN Enable — On
Off*
Lets you use the wireless
network connection.
0. Network Reset — — Restores all network
settings to the factory
settings.
Level1 Level2 Level3 Options Descriptions Page
3.Print Reports
(DCP-J100)
4.Print Reports
(DCP-J105)
1. User Settings — — Prints these lists and
reports.
See .
2.Network Config
(DCP-J105)
——
3.WLAN Report
(DCP-J105)
——
4.Machine Info.
(DCP-J100)
5.Machine Info.
(DCP-J105)
1.Serial No. — — Lets you check the serial
number of your machine.
58
2.Version — — Lets you check the
firmware version of your
machine.
See Advanced User’s Guide.
See Quick Setup Guide.
The factory settings are shown in Bold with an asterisk.
Level1 Level2 Level3 Options Descriptions Page
See Software and Network User’s Guide.
The factory settings are shown in Bold with an asterisk.