Brother DCP-J140W

ControlCenter2
127
7
OCR (word processing application) 7
Scan to OCR converts the graphic page image data into text which can be edited by any word processing
application. You can change the default word processing application.
Note
To use this feature, you must install Presto! PageManager from Brother Support on the installation
CD-ROM or go to http://nj.newsoft.com.tw/download/brother/PM9SEInstaller_BR_multilang.dmg.
To configure Scan to OCR, click the button while holding down the Ctrl key and choose Software Button.
To change the word processing application, choose the destination word processing application from the
Target Application drop-down list. You can add an application to the list by clicking the Add button. To
delete an application, click the Delete button.
If you want to scan and then crop a portion of a page after pre-scanning the document, check the
Show Scanner Interface box.