Brother DCP-J4110DW - Page 68

60
Unusable Device
Disconnect device
from front connector
& turn machine off &
then on
A broken device has been connected
to the USB direct interface.
Unplug the device from the USB direct
interface, then press to turn the
machine off and then on again.
Unusable Device
Please Disconnect
USB Device.
A USB device or USB Flash memory
drive that is not supported has been
connected to the USB direct interface.
For more information, visit us at
http://solutions.brother.com/
.
Unplug the device from the USB direct
interface. Turn the machine off and
then on again.
Wrong Ink Colour An ink cartridge has been installed in
the wrong position.
Check which ink cartridges are not
matched by colour to their ink
cartridge positions and move them to
their correct positions.
Wrong Paper The paper size setting does not match
the size of paper in the tray.
1 Make sure the paper size you
choose matches the size of paper
in the tray. (See Paper Size
on page 24.)
2 Make sure you loaded the paper in
the correct orientation by setting
the paper guides at the indicators
for your paper size. (See Loading
paper and other print media
on page 12.)
3 After you have checked the paper
size and the paper orientation,
press OK on the Touchscreen.
The paper orientation is not correct for
the paper size.
You did not set the paper guides in the
tray to the indicators for the paper size
you are using.
Error Message Cause Action