Home > Machine Settings > Change Machine Settings from the Control Panel > General Settings > Set
Tone or Pulse Dialling Mode
Set Tone or Pulse Dialling Mode
Related Models: MFC-J491DW/MFC-J497DW/MFC-J890DW/MFC-J895DW
Your Brother machine is set for a Tone dialling service. If you have a Pulse dialling (rotary) service, you must
change the dialling mode.
This feature is not available in some countries.
>> MFC-J491DW/MFC-J497DW
>> MFC-J890DW/MFC-J895DW
MFC-J491DW/MFC-J497DW
1. Press Settings.
2. Press a or b to select the following:
a. Select [Initial Setup]. Press OK.
b. Select [Tone/Pulse]. Press OK.
c. Select [Tone] or [Pulse]. Press OK.
3. Press Stop/Exit.
MFC-J890DW/MFC-J895DW
1. Press [Settings] > [All Settings] > [Initial Setup] > [Tone/Pulse].
2. Press [Tone] or [Pulse].
3. Press .
Related Information
• General Settings
• Telephone and Fax Problems
558
To Next Page
Loading...
