Home > Paper Handling > Load Documents > Load Documents in the Automatic Document Feeder (ADF)
Load Documents in the Automatic Document Feeder (ADF)
Use the ADF when copying or scanning multiple-page, standard-sized documents.
• The ADF can hold the following pages and feed each sheet individually:
- (DCP-L5500D)
up to 40 pages
- (MFC-L5700DN/MFC-L5755DW)
up to 50 pages
- (MFC-L5900DW/MFC-L6700DW)
up to 70 pages
- (MFC-L6900DW)
up to 80 pages
• Use standard 80 g/m
2
paper.
• Make sure documents with correction fluid or written in ink are completely dry.
IMPORTANT
• DO NOT leave thick documents on the scanner glass. If you do this, the ADF may jam.
• DO NOT use paper that is curled, wrinkled, folded, ripped, stapled, paper-clipped, pasted, or taped.
• DO NOT use cardboard, newspaper, or fabric.
• To avoid damaging your machine while using the ADF, DO NOT pull on the document while it is feeding.
Document Sizes Supported
Length:
147.3 to 355.6 mm
Width: 105 to 215.9 mm
Weight:
64 to 90 g/m
2
1. Unfold the ADF document output support flap.
2. Fan the pages well.
3. Stagger the pages of your document and load it face up and top edge first, into the ADF as shown in the
illustration.
44
To Next Page
Loading...
Need help?
General
