Brother DCP-L5652DN - Page 299

Home > Fax > Telephone Services and External Devices > External and Extension Telephones > Use the
Remote Codes
Use the Remote Codes
Related Models: MFC-L5700DW/MFC-L5705DW/MFC-L5800DW/MFC-L5850DW/MFC-L5900DW/
MFC-L6700DW/MFC-L6800DW
Fax Receive Code
If you answer a fax call on an extension telephone, you can tell your machine to receive it by pressing the Fax
Receive Code *51. Wait for the chirping sounds, and then replace the handset.
If you answer a fax call at the external telephone, you can make the machine receive it by pressing the buttons in
the following table:
Applicable Models
To make the machine receive the fax
MFC-L5700DW/MFC-L5705DW/MFC-L5800DW/MFC-L5850DW/
MFC-L5900DW/MFC-L6700DW/MFC-L6800DW
Fax Start and then Receive
Telephone Answer Code
If you receive a voice call and the machine is in F/T mode, it will start to sound the F/T ring (pseudo/double-ring)
after the initial ring delay. If you pick up the call on an extension telephone you can turn the F/T ring off by
pressing #51 (make sure you press this between the rings).
If the machine answers a voice call and pseudo/double-rings for you to take over, you can take the call at the
external telephone by pressing the button in the following table:
Applicable Models
To pick up voice call
MFC-L5700DW/MFC-L5705DW/MFC-L5800DW/MFC-L5850DW/
MFC-L5900DW/MFC-L6700DW/MFC-L6800DW
Pickup
Related Information
• External and Extension Telephones
• Change the Remote Codes
292