Brother DCP-L8400DN Advanced User's Guide

Chapter 1
6
Changing the prefix number 1
a Press .
b Press All Settings.
c Swipe up or down, or press a or b to
display Initial Setup.
d Press Initial Setup.
e Swipe up or down, or press a or b to
display Dial Prefix.
f Press Dial Prefix.
g Press On (or Off).
You can turn off the prefix number by
pressing Off. The prefix number will
remain off until you press On.
h Press Dial Prefix.
i Do one of the following using the
Touchscreen's keyboard.
 To change the prefix number, press
d or c to position the cursor under the
digit to be deleted and press the
Back Space button . Then press
the correct digit.
Repeat until the prefix number is
correct, and then press OK.
 To exit without making a change,
press OK.
NOTE
• You can use the numbers and symbols 0
to 9, #, and l. (You cannot use ! with any
other numbers or symbols.)
• If your telephone system requires a time
break recall (hookflash), press ! on the
Touchscreen.
• If pulse dialing mode is on, # and l are not
available to use.
j Press .
Setting the Fax Logic
(sending and receiving
sequence)
1
You can change the process of manual fax
send or receive. If you often send or receive
a fax manually to/from the other party at the
end of a conversation, set the Fax Mode to
Easy Mode.
If you set to Easy Mode : You can send or
receive a fax manually just simply press
Fax
Start
. Make sure the other party's machine is
ready to send or receive a fax. If you are a caller,
press
Fax Start to send a fax. If you are a
receiver, press
Fax Start to receive a fax.
If you set to Advanced Mode : No matter you
are a caller or receiver, you can choose you will
send or receive a fax manually. When you press
Fax Start , the machine will ask you to
choose
Send or Receive . If you want to send
a fax, press
Send to send a fax. If you want to
receive a fax, press
Receive to receive a fax.
NOTE
Even if you set either Easy Mode or
Advanced Mode and if there is a
document in the ADF, the document in the
ADF will be sent by pressing Fax Start.
a Press .
b Press All Settings.
c Swipe up or down, or press a or b to
display Fax.
d Press Fax.
e Swipe up or down, or press a or b to
display Miscellaneous.
f Press Miscellaneous.
g Press Fax Mode.
h Press Easy Mode or Advanced Mode.
i Press .

Brother DCP-L8400DN Specifications

General

Brand	Brother
Model	DCP-L8400DN
Category	All in One Printer
Language	English