Brother DCP-T500W - Sleep Mode; Auto Power off (DCP Models Only)

General setup
3
1
Sleep Mode 1
You can choose how long the machine must
be idle (up to 60 minutes) before it goes into
Sleep Mode. The timer will restart if any
operation is carried out on the machine.
(MFC-T800W)
1
a Press Menú (Menu), 2, 6.
b Press a or b to choose 1 Min, 2 Mins,
3 Mins, 5 Mins, 10 Mins, 30 Mins
or 60 Mins.
Press OK.
c Press Detener/Salir (Stop/Exit).
(DCP-T300, DCP-T500W and DCP-T700W)
1
a Press Menú (Menu).
b Press a or b to choose
0.Initial Setup .
Press OK.
c Press a or b to choose 3.Sleep Mode.
Press OK.
d Press a or b to choose 1 Min, 2 Mins,
3 Mins, 5 Mins, 10 Mins, 30 Mins
or 60 Mins, which is the length of time
the machine is idle before entering
Sleep Mode.
Press OK.
e Press Detener/Salir (Stop/Exit).
Auto Power Off
(DCP models only)
1
The Auto Power Off feature will turn off the
machine after it has been in Sleep Mode for
the number of hours you set. When this
feature is Off, the machine will remain in
Sleep Mode and not turn itself off.
The default setting is Off.
To turn on the machine after the Auto Power
Off feature has turned it off, press Power
On/Off.
NOTE
(DCP-T500W and DCP-T700W)
The machine will not power off
automatically when:
• the machine is connected to a wireless
network
• WLAN Enable is set to On.
a Press Menú (Menu).
b Press a or b to choose
0.Initial Setup.
Press OK.
c Press a or b to choose
5.Auto Power Off .
Press OK.
d Press a or b to choose 1hour, 2hours,
4hours, 8hours or Off.
Press OK.
e Press Detener/Salir (Stop/Exit).