Brother HL-4000CN - Page 36

1-9
1
1
.
.
2
2
.
.
2
2
S
S
e
e
t
t
t
t
i
i
n
n
g
g
P
P
r
r
o
o
t
t
o
o
c
c
o
o
l
l
s
s

Look
2When the printer is shipped from the factory, all protocols except FTP’ are active by
default. Normally you do not need to perform the operations described in this
section when you connect a new printer to a network for the first time. If you need to
change any of the default Protocol settings, follow the steps outlined in this section.
3This concludes the printer settings. Move on to 1.2.3 “Confirming Settings”.
Supported Protocols
• For TCP/IP(LPD) → [LPD] protocol
• For port 9100 → [Port9100] protocol
• For IPP → [IPP] protocol
• For NetBIOS (transport protocol: TCP/IP) → [NetBIOS TCP/IP] protocol
• For NetBIOS (transport protocol: NetBEUI) → [NetBIOS NetBEUI] protocol
• For NetWare → [NetWare] protocol
• For AppleTalk → [AppleTalk] protocol
 See
Refer to 5.2 “Basic Menu Operation” for information about the operation of the
control panel.