Brother HL-4000CN - Setting the IP Address

1-6
• IP Address ’192.168.1.100’
• Subnet mask ’255.255.255.0’
• Gateway Address ‘192.168.1.254’
Example:
 Setting the IP Address
✏ Note
The IP address consists of four separate values (base 10) separated by decimal
points. The 4 values can be set anywhere between 0 and 255.
Continued from the previous step
↓
TCP/IP
Setup IP Address
↓
10. Press the <
> button once.
TCP/IP
IP Address
↓
11. Press the <Form Feed/Set> or <
> button once.
IP Address
000.000.000.000*
↓
12. Using the <
> or < > button, press the buttons until
the desired value (for example, 192) appears. You can
hold down the buttons to change the value in increments
of 10.
IP Address
192.000.000.000
↓
13. Press the <
> button once and move the cursor to the
next value.
IP Address
192.000.000.000
↓
14. Repeat steps 12 and 13 to finish setting the IP address.
IP Address
192.168.001.100
↓
15. Press the <Form Feed/Set> button once.
Reboot system
To take effect
↓
3 seconds later, the following screen appears.
IP Address
192.168.001.100*
↓
16. Press the <Job Cancel/Back> or <
> button once.
The lower line of the screen returns to ‘IP address’.