Brother HL-4000CN - Set the IP Address Acquisition Method to Panel

1-4
1
1
.
.
2
2
C
C
o
o
n
n
f
f
i
i
g
g
u
u
r
r
i
i
n
n
g
g
t
t
h
h
e
e
P
P
r
r
i
i
n
n
t
t
e
e
r
r
o
o
n
n
a
a
N
N
e
e
t
t
w
w
o
o
r
r
k
k
This section describes configuring the printer for a network connection.
1
1
.
.
2
2
.
.
1
1
S
S
e
e
t
t
t
t
i
i
n
n
g
g
a
a
n
n
I
I
P
P
A
A
d
d
d
d
r
r
e
e
s
s
s
s
This section describes the procedure for setting the IP address, subnet mask, and
gateway address from the control panel of the printer.
Follow the steps below.

Look
0IP addresses are managed throughout the system as a whole. Specifying the wrong
IP address can affect the entire network. Before setting an IP address, consult your
system administrator.
 See
Refer to 5.2 “Basic Menu Operation” for further information about the operation of
the control panel.
 Set the IP address acquisition method to
‘Panel’.
Ready to Print
(The print screen. The printer is ready to print.)
↓
1. Press the <Menu> button. The menu screen appears.
Menu:
1:System
(The menu screen)
↓
2. Press the <
> button 4 times.
Menu:
5:Network
↓
3. Press the <Form Feed/Set> or <
> button once.
5:Network
Ethernet
↓
4. Press the <
> button once.
5:Network
TCP/IP
↓
5. Press the <Form Feed/Set> or <
> button once.
Continued