5-8
The table below describes the situations where the printer will stop being in energy
save mode:
Release from Energy Save
Mode 1
• When receiving print data.
• When printing a report or list with
‘4 Report/List’.
• Mode 1 timeout (default: 3 minutes)
Set a time between 1 and 120 minutes. The printer automatically goes into
energy save mode 1 when it is idle for the duration you set here.
Error Alarm
This allows you control if the printer sounds an audible alarm when an error occurs.
✏ Note
It is not possible to adjust the volume of the alarm.
To Next Page
Loading...
