Brother HL-4000CN - Page 38

1-11
Continued from the previous step
↓
Protocol
LPD
↓
6. Press the <
> button once.
1. Press the <Form Feed/Set>
button once. XXX indicates the
protocol name.
Protocol
Port9100
XXX
Disabled *
↓
7. Press the <
> button once. 2. Press the < > button once.
Protocol
IPP
XXX
Enabled
↓
8. Press the <
> button once.
Protocol
NetBIOS TCP/IP
↓
9. Press the <
> button once.
3. Press the <Form Feed/Set>
button once. ‘Reboot system to
take effect’ appears for 3
seconds, then following screen
appears.
Protocol
NetBEUI
XXX
Enabled *
↓
10. Press the <
> button once.
Protocol
NetWare
↓
11. Press the <
> button once.
Protocol
AppleTalk
4. To start other protocols, press
<Job Cancel/Back> or the <
> button once and continue to
the next step.
To finish the setting procedure,
go to step 12.
↓
12. Restart the printer.
Starting protocols