Brother HL-5450DN - Page 36

30
Configuring your machine for a wireless network (For HL-5470DW(T) and HL-6180DW(T))
3
a Press a or b to choose Network. Press OK.
b Press a or b to choose WLAN. Press OK.
c Press a or b to choose WPS w/PIN Code. Press OK.
d When WLAN Enable? is displayed, press a to accept.
This will start the wireless setup wizard.
To cancel, press Cancel.
e The LCD will show an 8 digit PIN and the machine starts searching for a WLAN access point/router.
f Using a computer that is on the network, type “http://access point’s IP address/” into your browser.
(Where “access point’s IP address” is the IP address of the device that is used as the Registrar
1
) Go to
the WPS setting page and input the PIN which the LCD shows in step e to the Registrar and follow the
on-screen instructions.
1
The Registrar is normally the WLAN access point/router.
Note
The setting page is different, depending on the brand of WLAN access point/router. See the instruction
supplied with your WLAN access point/router.
Windows Vista
®
/Windows
®
7 3
If you are using your computer as a Registrar, follow these steps:
Note
• To use a Windows Vista
®
or Windows
®
7 computer as a Registrar, you need to register it to your network
in advance. See the instruction supplied with your WLAN access point/router.
• If you use Windows
®
7 as a Registrar, you can install the printer driver after the wireless configuration by
following the on-screen instructions. If you want to install the full driver and software package, follow the
steps uu Quick Setup Guide for installation.