App. 2-1
Confidential
APPENDIX 2 DELETING USER SETTING
INFORMATION
The user setting information for the machine is stored in the main PCB. You can return this to
the default settings by following the procedure below.
<Operating Procedure>
LED models
(1) Press and hold the [Go] with the front
cover of the machine closed, and turn
ON the power switch of the machine.
Check that the Toner, Drum, and
Paper LEDs light.
(2) Release the [Go], and check that all
LEDs go out.
(3) Press the [Go] ten times. When
completed, the machine returns to the
ready state automatically.
LCD models
(1) Press the [▲] or [▼] to display “Initial
Setup” on the LCD, and press the
[OK].
(2) Press the [▲] and [Back]
simultaneously. “Reset” is displayed
on the LCD.
(3) Press the [OK]. “Machine Reset” is
displayed on the LCD.
(4) Press the [OK]. “▼Reset ▲Exit” is
displayed on the LCD, and press the
[▼].
(5) “Reboot OK?▼Yes ▲No” is displayed
on the LCD.
(6) Press the [▼] to delete the user
setting information and return the
machine to the ready state.
To Next Page
Loading...
Need help?
General