5-7
Confidential
1.3.2 Transition to shipping state (Function code 03)
The function code 03 includes following functions: Check sum information display for soft
switch, Default special operation setting, and Resetting to factory shipping state. Check sum
information display for soft switch is used by sales and production, not by servicemen.
Servicemen only use other one function: Resetting to factory shipping state.
Display soft switch check SUM
<Function>
This function is to display soft switch check SUM such as FSW/USW/WSW etc. Only for soft
switch display and not used for the service.
This function is displayed on LCD after enter function code 03 as “1.SWSUM?”.
Change ON/OFF setting of special function at start up
<Function>
By the special function at start up is set to an invalid state ([FUNC DISABLE]), “■ Transfer to
the shipping state” in the next item can be used. Be careful it is unable to transfer the
machine to the shipping state a valid state ([FUNC ENABLE]).
<Operating Procedure>
(1) Press the [▲] or [▼] in the initial state of maintenance mode to display “MAINTENANCE
03” on the LCD, and press the [OK].
“1.SWSUM?” is displayed on the LCD.
(2) Press the [▲] or [▼] to select “2.PowerOnFunc ?” and then press the [Go]. “FUNC
ENABLE” or “FUNC DISABLE” is displayed on the LCD.
(3) If “FUNC DISABLE” appears on the LCD, the machine's state is switchable to the factory
shipping state. Press and hold the [Go] for five seconds to return the machine to the
initial state of maintenance mode.
If “FUNC ENABLE” appears on the LCD, press the [▲] or [▼] to select “FUNC
DISABLE”, and press the [OK]. “1.SWSUM?” is displayed on the LCD; and the machine
returns to the initial state of the function code 03.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
