2-25
Confidential
Print Unable
E7
Turn the power off
and then back on
again.
Read error in the flash ROM
E702 2-51
Print Unable
E9
Turn the power off
and then back on
again.
An error occurred while
initializing the NFC.
E900 2-51
Print Unable
ZC
Turn the power off
and then back on
again.
Detected that supply power is
unstable. (less than 100 times)
6F00 2-44
Replace Drum -
Number of the drum unit
rotations has reached the upper
limit.
4200 2-38
Replace Toner -
Dot count or develop roller
counter of the toner cartridge in
models without toner box is
reaching the upper limit in the
continuous printing mode.
4D01 2-38
Open the Front
Cover, then install
Toner Cartridge
The amount of toner supplied of
the toner box has reached the
upper limit.
4C06 2-38
Open the Front
Cover, replace
Toner Cartridge.
Dot count or develop roller
counter of the toner cartridge in
models without toner box has
reached the upper limit in the
toner stop mode.
4C01 2-38
Self-
Diagnostic
Turn the power off,
then on again.
Leave the machine
for 15 min.
Some fuser unit errors occurred
at power-ON or upon recovery
from sleep mode.
6901 2-43
Will Automatically
Restart within 15
minutes.
After the error was detected at
the fuser unit, power was turned
ON again and the error is being
checked. (If power is turned
OFF and ON after error code
6901 occurred, this code is
displayed for about 15 minutes.)
6902 2-43
Size Error Specify the correct
paper size for Tray
1.
For printing by feeding paper
from the paper tray, the size of
paper specified from the driver
set the size which was not
supported by the paper tray.
9702 2-50
Error message
Description
Error
codes
Refer
to:
Initial display Scroll
To Next Page
Loading...
Need help?
General
Weight and Dimensions
