Brother MFC-210C User Manual

SETUP SEND 3 - 7
Dual Access (Not available for colour faxes)
You can dial a number, and begin scanning the fax into memory—
even when the MFC is sending from memory or receiving faxes. The
LCD shows the new job number and available memory.
Your MFC normally uses Dual Access. However, to send a
colour fax, the MFC will send the document in real time (even if
Real Time TX
is
Off
).
The number of pages you can scan into the memory will vary
depending on the data that is printed on them.
If you get an
Out of Memory
message while scanning the first
page of a fax, press
Stop/Exit
to cancel scanning. If you get an
Out of Memory
message while scanning a subsequent page,
you can press
Mono Start
to send the pages scanned so far,
or press
Stop/Exit
to cancel the operation.

Brother MFC-210C Specifications

General

Maximum print size	210 x 297 mm
Maximum ISO A-series paper size	A4
Maximum resolution	1200 x 6000 DPI
Print speed (black, normal quality, A4/US Letter)	20 ppm
Print speed (color, normal quality, A4/US Letter)	15 ppm
Faxing	No
Modem speed	14.4 Kbit/s
Copy speed (black, normal quality, A4)	17 cpm
Copy speed (color, normal quality, A4)	11 cpm
Scan speed	4 sec/page
Dimensions (WxDxH)	373 x 453 x 135 mm
Color all-in-one functions	copy, print, scan
Grayscale levels	256
Optical scanning resolution	600 x 2400 DPI
Number of print cartridges	4
Operating temperature (T-T)	5 - 35 °C
Operating relative humidity (H-H)	20 - 80 %
Total input capacity	100 sheets
Total output capacity	25 sheets
Market positioning	Home & office