Brother MFC-7440N

Troubleshooting and routine maintenance
117
B
Out of Memory The machine’s memory is full. Fax sending or copy operation in
progress
Do one of the following:
 Press Start to send or copy the scanned
pages.
 Press Stop/Exit and wait until the other
operations in progress finish, and then try
again.
 Clear the data from the memory. (See
Out of memory message on page 40 or
page 79.)
Print operation in process
Do one of the following:
 Reduce print resolution. (See Advanced
tab in the Software User’s Guide on the
CD-ROM.)
 Clear the faxes from the memory. (See
Out of memory message on page 79.)
Print Unable XX
(XX = Enter Code)
The machine has a mechanical
problem.
Do one of the following:
 (MFC-7340 and MFC-7440N only)
See Transferring your faxes or Fax
Journal report on page 118 before
disconnecting the machine so you will
not lose any important messages.
Then, disconnect the machine from the
power for several minutes and then
reconnect it.
 (MFC-7450, MFC-7840N and MFC-
7840W only)
Disconnect the machine from the power
for several minutes, then reconnect it.
(The machine can be turned off for up to
4 days without losing faxes stored in the
memory. See Transferring your faxes or
Fax Journal report on page 118.)
Error Message Cause Action