Setting Up the Machine
4
STEP 1
1 Removing the protective
parts
1 Remove the protective tape, then, starting from
the left hand side, carefully remove the scanner
glass protection sheet.
Improper Setup
DO NOT connect the USB cable. Connecting
the USB cable is done during the software
installation process.
2 Loading paper
You can load up to 100 sheets of 80 g/m
2
(20 lb) paper.
For details, see About paper in Chapter 2 of
the User’s Guide.
1 Pull the paper tray completely out of the
machine and remove the output paper tray (1).
2 Press and slide the paper guide (1) to fit the
paper width.
3 Pull out the paper support (1) and unfold the
paper support flap (2).
Note
Use the paper support flap for Letter, Legal and A4
paper.
11
11
1
2
To Next Page
Loading...
Need help?
General
