Wireless configuration for Windows
®
using the Brother installer application (For MFC-8890DW)
64
4
o If your network is configured for Authentication and Encryption, the following screen will appear. When
configuring your Brother wireless machine, you must configure your machine to match the
Authentication and Encryption settings you wrote down on page59 for your existing wireless
network. Choose the Authentication Method and Encryption Mode from the pull-down list in each
setting box. Then enter the Network Key and Confirm Network Key, and then click Next.
Note
• If you want to setup or configure additional WEP key indexes other than WEP key1, click Advanced.
• If you do not know the Authentication or Encryption settings for your network, contact your network
administrator or the manufacture of your access point / router.
• If you are using WEP and the printed Network Configuration page in step p shows Link OK in the
Wireless Link Status, but the machine is not found, make sure you entered the WEP key correctly. The
WEP key is case sensitive.
To Next Page
Loading...
Need help?
General
