Brother MFC-8710DW - 4 Sending a Fax; How to Send a Fax

26
4
How to send a fax 4
The following steps show you how to send a
fax.
a When you want to send a fax, or change
fax send or receive settings, press the
(FAX) key to illuminate it in blue.
 The LCD shows:
b Do one of the following to load your
document:
 Place the document face up in the
ADF. (See Using the automatic
document feeder (ADF)
uu page 24.)
 Load your document face down on
the scanner glass. (See Using the
scanner glass uu page 25.)
Note
To send faxes with multiple pages use the
ADF.
c Do one of the following:
 If you want to change fax resolution,
press b and press d o r c to choose
fax resolution.
Press OK.
 To send the document, go to
Step d.
d (MFC-8910DW)
Do one of the options below:
 If you want to send a single-sided
document, go to Step e .
 If you want to send a 2-sided
document, press Duplex.
Note
• You can send 2-sided documents from the
ADF.
• When the machine is ready to scan
2-sided documents the LCD shows for
Duplex in the lower right corner.
e Enter the fax number by using the dial
pad (up to 40 digits), by pressing a One
Touch key, or by pressing (Address
Book) twice and entering a three-digit
Speed Dial number.
Sending a fax 4
01/01/2012 03:00PM
Fax
Res:Standard
b
Press b or Dial