Brother MFC-8912DW - Page 95

2-50
Confidential
 Error code 9500
When printing from paper tray 2, the T2 paper feed sensor detected that there was no paper
set in paper tray 2.
 Error code 9600
When printing with the tray designation set to AUTO, the MP paper empty sensor, T1 paper
feed sensor and T2 paper feed sensor all detected that there was no paper set in the MP
tray, paper tray 1 and paper tray 2.
No Paper
Load #S paper in #T2.
<User Check>
• Set the paper in paper tray 2.
Step Cause Remedy
1
Connection failure of the T2
paper feed sensor harness
Check the connection of the T2 paper feed
sensor harness, and reconnect it if necessary.
2
T2 paper feed actuator caught
in some sections of the machine
Reattach the T2 paper feed actuator.
3 T2 paper feed actuator failure Replace the T2 paper feed actuator.
4
T2 paper feed sensor failure Refer to "1.3.10 Check sensor operation
(function code: 32)" in Chapter 5 to check the
sensor operation. If the sensor operation is
faulty, replace the T2 paper feed sensor PCB
ASSY.
5 T2 relay PCB failure Replace the T2 relay PCB ASSY.
6 LT connector failure Replace the LT connector
7 Main PCB failure Replace the main PCB ASSY.
(Non Touch panel model)
No Paper
Load #S paper in #T.
(Touch panel model)
No Paper
Load paper in Tray
<User Check>
• Set the paper in any tray.
Step Cause Remedy
1 Main PCB failure Replace the main PCB ASSY.