Chapter 2
20
Loading documents 2
Using the automatic
document feeder (ADF) 2
The ADF can hold up to 35 pages and feeds
each sheet individually. Use standard 20 lb
(80 g/m
2
) paper and always fan the pages
before putting them in the ADF.
Recommended environment 2
IMPORTANT
• DO NOT leave thick documents on the
scanner glass. If you do this, the ADF may
jam.
• DO NOT use paper that is curled,
wrinkled, folded, ripped, stapled, paper-
clipped, pasted or taped.
• DO NOT use cardboard, newspaper or
fabric.
• To avoid damaging your machine while
using the ADF, DO NOT pull on the
document while it is feeding.
Note
To scan documents that are not suitable
for the ADF, see Using the scanner glass
on page 21.
Make sure documents with correction fluid
or written with ink are completely dry.
a Unfold the ADF document output
support flap (1) and the ADF support
flap (2).
b Fan the pages well.
c Place your document face up, top edge
first in the ADF until the LCD display
message changes and you feel it touch
the feed rollers.
d Adjust the paper guides (1) to fit the
width of your document.
Temperature: 68 °F to 86 °F (20 to 30 °C)
Humidity: 50% - 70%
Paper: Xerox 4200 (20 lb/Letter)
1
2
1
To Next Page
Loading...
Need help?
General
