Brother MFC-9140CDN - Basic Machine Operations

24
For Wireless Network Users
f Temporarily connect the USB cable (not
included) directly to the computer and the
machine.
g Do one of the following:
 If the Installation confirmation screen
appears, check the box and click Next, and
then go to h.
 If the Installation confirmation screen
does not appear, go to i.
h Check Yes if you want to connect with the listed
SSID. Click Next, and then go to k.
i The wizard will search for available wireless
networks from your machine. Choose the SSID
that you wrote down for your network in step
17-a on page 21, and then click Next.
j Enter the Network Key you wrote down in step
17-a on page 21, and then click Next.
k Confirm the wireless network settings, and
then click Next. The settings will be sent to your
machine.
l Disconnect the USB cable between the
computer and the machine, and then click
Next.
To install the MFL-Pro Suite, continue to
step 20.
For Windows
®
Users:
Now go to
step 20-e on page 32
For Macintosh Users:
Now go to
step 20-d on page 34
NOTE
If the Important Notice screen appears, read the
notice. Check the box after you confirm the SSID
and Network Key, and then click Next.
NOTE
• If the list is blank, check that the wireless access
point/router has power and is broadcasting the
SSID. See if the machine and the wireless
access point/router are within range for wireless
communication. Click Refresh.
• If your wireless access point/router is set to not
broadcast the SSID, manually add it by clicking
the Advanced button. Follow the on-screen
instructions for entering the Name(SSID), and
then click Next.
NOTE
If your network is not configured for
Authentication and Encryption, the ATTENTION!
screen will appear. To continue configuration,
click OK.
NOTE
• The settings will remain unchanged if you click
Cancel.
• To manually enter the IP address settings of
your machine, click Change IP Address and
enter the necessary IP address settings for your
network.
• If the wireless setup failure screen appears,
click Retry.
Wireless setup is now complete.
A four-level indicator at the top right of
your machine’s Touchscreen will show
the wireless signal strength of your
wireless access point/router.