Brother MFC-9320CW - Manual Configuration from the Control Panel

33
For Wireless Network Users
Wireless Network
Windows
®
Macintosh
Manual configuration from the control panel
17
Configure the wireless
settings
a On your machine, press Menu, 7 (Network), 2
(WLAN), 2 (Setup Wizard).
Press 1 to choose On.
b The machine will search for available SSIDs. If
a list of SSIDs is displayed, use a or b to
choose the SSID you wrote down in step 16-b
on page 29, then press OK. Go to step f.
If your access point is set to not broadcast the
SSID you will have to manually add the SSID
name. Go to step c .
c Press a or b to choose <New SSID> and press
OK. Go to step d.
d Enter the SSID you wrote down in step 16-b on
page 29 using the dial pad to choose each
letter or number.
You can use d and c to move the cursor left and
right. For example, to enter the letter a, press
the 2 key on the dial pad once. To enter the
number 3, press the 3 key on the dial pad
seven times.
The letters appear in this order: lower case,
upper case and then numbers.
(For more information, see Entering Text for
Wireless Settings on page 47.)
Press OK when you have entered all the
characters.
e Press a or b to choose Infrastructure,
then press OK.
f Use the a, b and OK keys to choose one of the
options below: If your network is configured for
Authentication and Encryption you must match
the settings used for your network.
 No Authentication or Encryption:
Choose Open System, press OK then
choose None for Encryption Type? and
press OK. Then press 1 for Yes to apply
your settings. Go to step k.
 No Authentication with WEP Encryption:
Choose Open System, press OK then use
a or b to choose WEP for the
Encryption Type? and press OK.
Go to step g.
 Authentication with WEP Encryption:
Choose Shared Key and press OK.
Go to step g.
 Authentication with WPA/WPA2-PSK
(TKIP or AES) Encryption:
Choose WPA/WPA2-PSK and press OK.
Go to step h.
 Authentication with LEAP:
Choose LEAP, press OK. Go to step i.
 Authentication with EAP-FAST/NONE,
EAP-FAST/MS-CHAPv2, EAP-FAST/GTC
(TKIP or AES Encryption):
Choose EAP-FAST/NONE,
EAP-FAST/MSCHAP (EAP-FAST/MS-
CHAPv2) or EAP-FAST/GTC, press OK. Go
to step j.
g Choose the appropriate key number and press
OK. Enter the WEP key you wrote down in
step 16-b on page 29 using the dial pad to
choose each letter or number.
For example, to enter the letter a, press the 2
key on the dial pad once. To enter the number
3, press the 3 key on the dial pad seven times.
The letters appear in this order: lower case,
upper case and then numbers.
(For more information, see Entering Text for
Wireless Settings on page 47.)
Press OK when you have entered all the
characters, then press 1 for Yes to apply your
settings. Go to step k.
Note
It will take several seconds to display a list of
available SSIDs.