Brother MFC-J200 - Page 112

104
Menu (continued) C
5.Network
(Continued)
4.WPS/AOSS — — You can easily configure
your wireless network
settings using the one-
button push method.
See .
5.WPS w/PIN Code — — You can easily configure
your wireless network
settings using WPS with
a PIN code.
6.WLAN Status 1.Status — You can see the current
wireless network status.
2.Signal — You can see the current
wireless network signal
strength.
3.SSID — You can see the current
SSID.
4.Comm. Mode — You can see the current
Communication Mode.
7.MAC Address — — You can see your
machine’s MAC address
from the control panel.
8.WLAN Enable — On
Off*
Lets you use the wireless
network connection.
0. Network Reset — — Restores all network
settings to the factory
default.
Level1 Level2 Level3 Options Descriptions Page
6.Print Reports 1.XMIT Verify — — Prints these lists and
reports.
See .
2.Address Book ——
3.Fax Journal ——
4. User Settings ——
5.Network Config ——
6.WLAN Report ——
7.Caller ID
(Only available
for some
countries)
——
See Advanced User’s Guide.
See Quick Setup Guide.
The default settings are shown in Bold with an asterisk.
Level1 Level2 Level3 Options Descriptions Page
See Software and Network User’s Guide.
The default settings are shown in Bold with an asterisk.