Brother MFC-J200 - 10 How to Scan to a Computer; Before Scanning; Scanning a Document as a PDF File Using Controlcenter4 (Windows ); Controlcenter4 (Windows)

50
10
Before scanning 10
To use the machine as a scanner, install a scanner driver. If the machine is on a network,
configure it with a TCP/IP address.
 Install the scanner drivers from the CD-ROM. (See Quick Setup Guide: Install MFL-Pro Suite.)
 Configure the machine with a TCP/IP address if network scanning does not work.
(See Software and Network User’s Guide.)
Scanning a document as a PDF file using
ControlCenter4 (Windows
®
) 10
(For detailed information, see Software and Network User’s Guide.)
NOTE
• The screens on your PC may vary depending on your model.
• This section is based on using the Advanced Mode of ControlCenter4.
ControlCenter4 is a software utility that lets you quickly and easily access the applications you use
most often. Using ControlCenter4 eliminates the need to manually launch specific applications.
a Load your document. (See How to load documents on page 20.)
b (Windows
®
XP, Windows Vista
®
and Windows
®
7)
Open ControlCenter4 by clicking (Start)/All Programs/Brother/MFC-XXXX (where
XXXX is your model name)/ControlCenter4. The ControlCenter4 application will open.
(Windows
®
8)
Click (Brother Utilities), and then click the drop-down list and select your model name
(if not already selected). Click SCAN in the left navigation bar, and then click
ControlCenter4. The ControlCenter4 application will open.
How to scan to a computer 10