Troubleshooting
71
B
Out of Memory The machine's memory is full. If a fax-sending or copy operation
is in process:
Press Stop/Exit and wait until the
other operations that are in
process finish, and then try again.
Press Mono Start or
Colour Start to choose Send to
send the pages scanned so far.
Press Mono Start or
Colour Start to print the pages
scanned so far.
Clear the data in the memory. To
gain extra memory, you can turn
off Memory Receive.
(See Advanced User’s Guide:
Turning off Memory Receive
operation.)
Print the faxes that are in the
memory. (See Advanced User’s
Guide: Printing a fax from the
memory.)
Paper Jam The paper is jammed in the machine. Remove the jammed paper by
following the steps in Printer jam or
paper jam on page 75.
Make sure the paper length guide is
set to the correct paper size.
DO NOT extend the paper tray when
you load A5 or smaller size paper.
(The extendable tray is only available
for some countries.)
If there is a repeat paper jam, a small
piece of paper may be stuck in the
machine. Make sure paper is not still
jammed in the machine. (See
Additional paper jam clear operations
on page 78.)
Paper dust has accumulated on the
surface of the paper pick-up rollers.
Clean the paper pick-up rollers.
(See Advanced User’s Guide:
Cleaning the paper pick-up rollers.)
Error Message Cause Action
To Next Page
Loading...
