59
ERROR MESSAGE LIST
TEXT TOO HIGH! ● This message appears if the size
of the text is larger than the
width of the installed tape.
● (PT-9600 only) This message
appears if the Lines of Text set-
ting for the ESC/P interface
mode exceeds the maximum
possible for the installed tape.
● Reduce the size of the
characters, install a tape
with a greater width or
select the AUTO text size
setting.
● Specify the correct setting
for the installed tape.
TEXT TOO LONG! ● This message appears if the
length of the text is longer than
the label length that has been
set with the Tape length func-
tion.
● This message appears if you try
to print a label that is longer
than the maximum label length.
● This message appears if you try
to print a label that is longer
than the maximum label length
or is longer than the specified
block length.
● This message appears if the
length of the text is longer than
the width of the tape when the
Text rotation function is used.
● Delete some of the text,
reduce the character
width, or increase the set
label length.
● Delete some of the text or
reduce the character size.
VALUE OUT OF RANGE!
CHECK VALUE AND
RE-ENTER.
● This message appears if the
value entered while setting the
Tape margin, Tape length, Block
margin and Block length func-
tion is not within the allowable
range.
● This message appears if the
specified characters cannot be
found in the database.
● This message appears if the val-
ues for the records to be printed
is not within the allowable
range.
● Type in a value that is
within the allowable
range.
WRONG ADAPTER! ● This message appears if an
extremely high-voltage or
extremely low-voltage adapter
is being used.
● Disconnect the adapter,
and connect the adapter
designed exclusively for
this machine.
WRONG CHARACTER! ● This message appears if a time
stamp or user-defined character
image is selected when you try
to use the Numbering function.
● Select text or a barcode
before trying to use the
Numbering function.
ERROR MESSAGE CAUSE SOLUTION
To Next Page
Loading...
