HELPFUL HINTS
Reset your P-touch labelling machine when you
want to initialise the settings, or in the event it is
not working correctly. Resetting clears all the
text, settings, and stored files.
1 Turn off the P-touch labelling machine,
hold down and , and then
press to turn the P-touch labelling
machine back on.
2 First release the power button, and then
release and .
The P-touch labelling machine turns on with
the internal memory reset.
NOTE
Shortcuts
Language
Space key
Undl/Frame
Label Length
Margin
CableRot/Rpt
File
Tab
Tab Length
Unit
LCD contrast
Resetting the P-touch
Labelling Machine
CAUTION
USING A COMBINATION OF DIFFERENT
BATTERIES (SUCH AS ALKALINE WITH
Ni-MH), MAY RESULT IN AN EXPLOSION.
DISPOSE OF USED BATTERIES
ACCORDING TO THE INSTRUCTIONS.
• Remove the batteries if you do not intend
to use the P-touch labelling machine for an
extended period of time.
• Dispose of batteries at an appropriate
collection point, not in the general waste
stream. Be sure to observe all applicable
federal, state, and local regulations.
• When storing or discarding a battery, wrap
it with cellophane tape to prevent it from
short-circuiting (see illustration).
1. Cellophane tape
2. Alkaline or
Ni-MH battery
Do not mix old and new batteries. Replace all
six batteries at the same time.
2
1
To Next Page
Loading...
