Brother P-touch E110 - Supplies and Accessories; Specifications

If the cutter blade becomes blunt after repetitive
use and the tape cannot be cut cleanly, rotate the
cutter board as shown in the illustration
1.
If you still have difficulties, replace with a new
cutter unit (stock no. TC-4) from an authorised
Brother reseller.
 Replacing the Cutter Unit
1. Remove the two sections of the Cutter Unit
(green) in the direction of the arrows as
illustrated below
2.
2. Install a new Cutter Unit. Push it in gently
until it locks into place.
*1 Visit support.brother.com
for the latest
information about the recommended
batteries.
Supplies and Accessories
Cassettes: Visit the Brother Solutions
Center at support.brother.com
for the latest information about
consumables.
AC Adapter: AD-24ES
Cutter Unit: TC-4 (replacement)
WARNING
Do not touch the cutter blade directly with your
fingers.
Cutter Board
Specifications
Dimensions:
(W x D x H)
Approx. 109(W) X 202(D) X 55(H) mm
Weight: Approx. 400 g
(without batteries and tape cassette)
Power supply: Six AAA alkaline batteries (LR03)
Six AAA Ni-MH batteries (HR03)
*1
Optional AC Adapter (AD-24ES)
Tape cassette: Brother P-touch TZe tape widths:
3.5 mm, 6 mm, 9 mm, 12 mm
Brother HGe tape widths:
6 mm, 9 mm, 12 mm