MONITORING SYSTEM
PILOT
LAMP(S)
ON
BEEPER
MESSAGE
DISPLAY
DESCRIPTION
—
4short
beeps
every
5
minutes
REV LIMIT
Engine RPM limite d for protection when
certain faults occur.
——
OVER REV
Indicates that maximum engine RPM is
reached. Check clutch calibration.
—
Short
beeps
repeating
rapidly
SHUTDOWN
Shutdown procedure in force d ue to e ngine
overheating or fuel pump problem, remove
tether cord cap from engine cut-off switch
and contact an authorized Lynx dealer.
——
COMMUNICATION
Communication pro blem b etwee n ECM
and gauge. Stop engine, remove tether
cord cap . Wait a few minutes, then start
engine. If problem persists, contact an
authorized Lynx dealer.
2short
beeps
—
Good key, vehicle ready to ope rate.
2short
beeps,
repeating
slowly
CHECK KEY
Unable to read key (bad connection). Make
sure the key is clean and correctly snapped
on post.
D.E.S.S.
Short
beeps
repeating
rapidly
BAD KEY
Invalid key or key not pr ogrammed. Use
the proper key for the vehicle or have the
programmed.
——
(blinking)
Fuel level sensor problem.
——
THROTTLE OPEN
Throttle lever applied while attempting an
engine start (engine cranks but won't run).
Release throttle while starting.
——
DROWN MODE
Throttle lever wide open while attempting
an engine start (engine cran ks but won't
run). Release throttle while starting.
______________
119
To Next Page