CONTROLS, INSTRUMENTS AND EQUIPMENT
4) Pilot Lamps and Messages
mmo2008-003-024_a
TYPICAL — PILOT LAMPS
See table below for usual pilot lamps information. Refer to
MONITORING SYS-
TEM
for details on malfunction pilot lamps .
PILOT
LAMP(S)
ON
BEEPER MESSAGE DISPLAY DESCRIPTION
Injection oil level is low. Stop vehicle in a safe place then,
replenish injection oil reservoir.
4short
beeps
every
5 minutes
LOW OIL
Refer to
MONITORING SYSTEM
.
——
Low fuel level. One (1) bar left in fuel level display.
Replenish fuel tank as soon as possible.
Long
beeps
repeating
slowly
REVERSE Reverse is selected.
3short
beeps
REV. FAIL Reverse did not engage, try again.
——
High beam headlights are selected.
— —
WARM UP
Engine and/or injection o il n eed to warm-up before n ormal
operation. The engine's RPM is limited until desired
temperature is reached (up to 10 minutes when driving).
Warm-up period may occur after a restart in very cold
weather.
5) MODE (M) Button
Button use to navigate in gauge multifunction display.
NOTE: MODE(M)buttononthemulti-switchhousinghasthesamefunctionsand
canalsobeused.
6) SET (S) Button
Button used to nav iga te, adjust or reset ga uge multifunction display.
In order to memorize settings, engine must be running.
NOTE: SET(S)buttononthemultifunctionswitchhasthesamefunctionsandcan
also be used.
42
______________
To Next Page
Loading...
