8 (53) BRUKER BIOSPIN Operating & Service Manual Version 002
Safety
Manufacturer’s Name Plate 2.1.2
The BLAH1000 E Amplifier 700-900MHz can be identified by a manufacturer’s
name plate at the back panel of the unit that contains the country of origin of
manufacture.
Figure 2.2. Manufacturer’s Name Plate
Safety Labels and Symbols 2.2
Warning Signs 2.2.1
Risk of Danger
Operating Instruction
Operating personal should not remove RF output cable without turn off the power
supply because the RF output can cause serious burns before the "Mismatch"
protection is active.
Please disconnect the mains supply before opening to prevent potential hazard
such as :
• Electrical shock from power supply
• Contact burns from the RF module and heatsink
• Finger scratch due to the fan assembly on the RF module.
DANGER! Risk of electrical shocks
Throughout this manual, this symbol indicates the possibility of
severe personal injury, loss of life or equipment damage if the
instructions are not followed.
On the equipment, the symbol also implies a danger and alerts the
user.
Made in France
To Next Page
Loading...
General