5
11 Lift the tool via both sides of the bridge. Be very careful not to touch the center where the head is located.
Place the tool on the surface that will be its final location—either a sturdy workbench or a vibration isolation
table. Make sure that there is plenty of front and back access room for performing the installation steps
outlined in the section that follows.
12 Remove and unpack the box containing one or more styli and the stylus exchange tool.
13 Remove the EMO box.
14 After you have unpacked all of the boxes, find the shipping checklist that was located in the computer
documentation and cable box. Do a complete inventory of all of the items shown on the checklist before
discarding the packing materials. If anything is missing, recheck the boxes. If you have any questions, call
Bruker Customer Service at
800-873-9750.
To Next Page
Loading...
