4
7 Remove the top half of the foam, and you will see the monitor with the screen facing down. Take the
monitor out of the foam and set it on a clean, flat surface with the screen facing down. Attach the stand to
the monitor.
8 This is the environmental enclosure box. Although it is similar in size to the box that contains the DektakXT
stylus profiler, it is much lighter.
9 Remove the environmental enclosure and place it on a table near the final location of the DektakXT tool.
10 This is the box that holds the DektakXT stylus profiler. The tool is very heavy, so you will need two people
to lift it.
To Next Page
Loading...
Need help?
General
