Bruker NMR 400 89 Ascend DNP - Setting the Magnet System into Operation

39
ZTKS0243 / Z31993 / 03
Operation
5.3 Set into Operation
Figure 5.1: Start the Magnet Stand
If the magnet system is equipped with a magnet
stand with pneumatic isolators:
Set the magnet stand into operation by switching
the pneumatic controller to UP position.
Figure 5.2: Stop the Magnet Stand
For any work at the magnet system like
maintenance or refill of cryogenic agents stop
the magnet stand by switching the pneumatic
controller to DOWN position.