18
PROGRAMMING THE THERMOSTAT
Setting the sleep temperatur e
1. Press the sleep button located under the display in the
center. You will see a triangle icon (B ) above the sleep
button.
2. You will see the heating and cooling temperatures that were
set at the factory. To use these, just close the door.
3. To change the factory settings, press the sleep button. You
will see the word heat flashing on the screen.
4. Press the up or down button on the right side of the dis-
play until you reach the desired temperature setting.
5. Press and hold the sleep button for about three seconds.
The set temperature will flash, indicating that it saved your
settings.
6. To change the cooling temperature setting, press the mode
button until you see the word cool flashing on the screen.
To Next Page
Loading...
Need help?
General
