Setting up the Printer
Make certain all the necessary components of the printer are
installed:
Preparing
the Media
• Is the printer plugged into a power outlet?
• Does the printer have at least three black print
cartridges installed in one of the Banks?
• Is the printer connected to the computer?
Now that the printer is installed the setup or adjustments to the
printer need to be done for it to work with the media. To avoid
problems of misfeeding and jams the media must also be made
ready for the printer.
Use the following steps to make the media ready for printing:
1. Take a manageable pile of media and while holding
them (as shown below in reference A), "fan" all sides
of the media to make sure that each piece of media is
free from one another.
Note: Maximum
thickness is 0.5”(1.27
cm).
2. Square the pile against the tabletop, assuring a square
pile on all sides. (Reference B) This will also allow
media to settle toward the bottom of a stuffed envelope
and will increase consistency in the print and increase
the feeding capabilities of the feeder.
Fan All Sides of Media Square Media
Revision C 30K USERS MANUAL Section 3 -
P/N 90-00203-001
7
To Next Page
Loading...
