Bryce 30K - Page 5

TABLE OF CONTENTS
Setting the H-Block Assembly ..........................................................5 - 4
Setting the Sliding Fence...................................................................5 - 5
Setting the Media Support Wedge.....................................................5 - 5
Setting up the Wide Media Shafts .....................................................5 - 6
Setting up and using the Feed Ramp Extension ................................5 - 7
PRINTER MENU SYSTEM Chapter 6
FRONT PANEL CONTROLS AND LCD DISPLAY..................................6 - 1
What does the display show...............................................................6 - 2
MAIN MENU................................................................................................6 - 3
• 1. Address Layout.......................................................................6 - 3
• 2. Print Quality............................................................................6 - 4
• 3. Font .........................................................................................6 - 5
• 4. Barcode...................................................................................6 - 6
• 5. Address Recovery...................................................................6 - 6
• 6. Clear Counter..........................................................................6 - 7
• 7. Job Settings.............................................................................6 - 7
• 8. Conveyer Time........................................................................6 - 8
• 9. Image Overlay.........................................................................6 - 8
• 10. Purge Print Head...................................................................6 - 9
• 11. Reset Ink Count ....................................................................6 - 9
SETUP MENU...............................................................................................6 - 10
• 1. Stop On Feed Error.................................................................6 - 10
• 2. Feeder Signal ..........................................................................6 - 10
• 3. Lines Per Address...................................................................6 - 11
• 4. Line Termination ....................................................................6 - 12
• 5. Hex Dump Mode.....................................................................6 - 12
• 6. Language.................................................................................6 - 12
• 7. Transport Speed......................................................................6 - 13
• 8. Postal Bundle Break................................................................6 - 14
• 9. Pre-Purge ................................................................................6 - 15
• 10. Feed Gap................................................................................6 - 15
• 11. Rom Revision#......................................................................6 - 16
• 12. Print Head Size .....................................................................6 - 16
SERVICE MENU..........................................................................................6 - 17
• 1. Adjust Print.............................................................................6 - 17
• 2. Test System.............................................................................6 - 20
• 3. Test Display............................................................................6 - 20
TROUBLESHOOTING & DIAGNOSTICS Chapter 7
SYMPTOMS & SOLUTIONS ..........................................................7 - 1
SYMPTOMS & SOLUTIONS when using the Bryce Feeder...........7 - 7
Revision C 30K USERS MANUAL Section i - 2
P/N 90-00203-001